Jump to content

Tube Bending


indigoxtreme02

Recommended Posts

hey guys, im new to inventor and im wondering if there is a way to make like 45 degree bends in tubing and things like that, thanks for the help

Link to comment
Share on other sites

hey guys, im new to inventor and im wondering if there is a way to make like 45 degree bends in tubing and things like that, thanks for the help

 

There must be several dozen methods depending on design intent. Everything from a simple Sweep of 2D Sketch to AutoBend in 3D Sketch to Routed Systems.

 

You might get an appropriate suggestion by attaching what you have so far.

 

I recommend going through the Inventor tutorials in my signature.

Link to comment
Share on other sites

Like JD said,lots of ways to do this.

 

The example above shows a very commom way to do it via the sweep, another that was introduced to 2008 is the bend command.

untitled 2.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...