humaironline Posted April 20, 2009 Share Posted April 20, 2009 I drawn a spiral stairs, in which i can't draw a horizontal railing. pls help me to draw it.... Quote Link to comment Share on other sites More sharing options...
fuccaro Posted April 20, 2009 Share Posted April 20, 2009 Draw a helix throu the ends of the vertical bars and extrude a circle along it. Your profile says that you use AutoCAD 2006 (nice image for 2006!) In AutoCAD 2006 there is no Helix command but there a re a lot of Lisp routines helping you to draw one -you may searc the internet or even this forum, in the AutoLisp section. Post again if you ned more help. Quote Link to comment Share on other sites More sharing options...
shift1313 Posted April 20, 2009 Share Posted April 20, 2009 thats exactly the way i would do it as well. since you have a center snap point on each hand rail just use the SPLINE command and snap to each center point. Then draw your rail profile at the start of your handrail. EXTRUDE>Path. Quote Link to comment Share on other sites More sharing options...
fuccaro Posted April 20, 2009 Share Posted April 20, 2009 Can you extrude along a spline? -Unfortunately I can not test it right now. Quote Link to comment Share on other sites More sharing options...
shift1313 Posted April 20, 2009 Share Posted April 20, 2009 you can but there are restrictions with the ucs. I dont recall exactly what they are pre07. 07+ doesnt have an issue with it but i know ive done this in 05. Quote Link to comment Share on other sites More sharing options...
humaironline Posted April 22, 2009 Author Share Posted April 22, 2009 Ya....i did it...by spline... thanks...shift1313 its cool to use spline command. Quote Link to comment Share on other sites More sharing options...
fuccaro Posted April 22, 2009 Share Posted April 22, 2009 Nice! I can not wait to see the whole building! Quote Link to comment Share on other sites More sharing options...
shift1313 Posted April 22, 2009 Share Posted April 22, 2009 Ya....i did it...by spline... thanks...shift1313 its cool to use spline command. glad it worked out for you! How are you going to end the hand rails? some sort of decorative end? if you need to you can use the Solidedit>face>extrude and add a little extra to the ends. it will be a straight extrusion but it will allow you to trim off the ends vertical with your supports. Quote Link to comment Share on other sites More sharing options...
fuccaro Posted April 23, 2009 Share Posted April 23, 2009 That "extruded end" can be also curved. If you draw an arc tangent to the helix you can extrude the ending cap along it. Here is what I mean: Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.