wakibd Posted May 6, 2009 Share Posted May 6, 2009 if any one knows any command that i can remove /trim all the line from the square boxes . I like to do one selection of all boxs and then use ( if any one have this command) this command delete all. I used trim/extrim command but i have to do selection each boxes seperately. i attached my copy remove.dwg Quote Link to comment Share on other sites More sharing options...
Strix Posted May 6, 2009 Share Posted May 6, 2009 sorry I can't see your dwg on this computer, but are you looking for WIPEOUT? Quote Link to comment Share on other sites More sharing options...
wakibd Posted May 7, 2009 Author Share Posted May 7, 2009 I am not looking for wipeout, i have lots of stormwater pit . the lines go through these pits . i like to select all pits and use one command ( if anyone have) to delete all the inside part of the lines which passes through the pits. not whole lines, only part of the line which is in the pit. my attached copy is fine. today i downloaded i is fine. Quote Link to comment Share on other sites More sharing options...
ReMark Posted May 7, 2009 Share Posted May 7, 2009 It almost sounds as though you're looking for an extended trim command. Have you taken a look at EXTRIM? Quote Link to comment Share on other sites More sharing options...
ReMark Posted May 7, 2009 Share Posted May 7, 2009 EXTRIM explained: http://autocadtipoftheday.com/tipblog/?p=332 Quote Link to comment Share on other sites More sharing options...
hazardman Posted May 8, 2009 Share Posted May 8, 2009 with extrim you would have to perform the command seperately for each pit as oppose to doing a multiple selection of all pits and perform that command in one swoop...i don't think there's anything that acad can do natively so it looks like a programming job in either lisp or vba... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.