Jump to content

Auto Wire Number


Electroman7979

Recommended Posts

I am trying to set up all my layers so I can keep all my 24VDC and 120VAC power separate. So when I click on the automatic wire numbers I can re-number all my wires at once.

However, this works fine when I click on "active drawing". But when I try to do multiple drawings or the whole project, it does the first page and then gives me this error:

 

" Wire numbers: 6 New, 0 Updated, 0 Fixed

Error: bad argument type: stringp nil"

 

Has anyone ran into similar issues? or do I have a something goofy going on?

 

Any help would be appreciated!

Thanks,

James

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...