Interior Posted May 18, 2009 Share Posted May 18, 2009 I'm not sure thats the best title but anyway what i want to do is move a line up to run under some stairs ( the one i constantly mentioned) and then extrude from there to make it appear more like a spine for the stair just off centre. i can get as far as getting the line correct postion under the stair flat not a at an angle but were to go from the there i don't no i have tried 3d rotate as wel as the the other rotage tool drawing it throught the stair in 2d but the result was really bad and more ideas would be really help. Thank you Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.