Jump to content

can't snap to intersection


michaeloureiro

Recommended Posts

just finished flattening a drawing but can´t seem to snap to intersecting lines. all of the lines are at 0,00.

 

can anybody help?

Link to comment
Share on other sites

just finished flattening a drawing but can´t seem to snap to intersecting lines. all of the lines are at 0,00.

 

Two things I've had problems with:

 

1. The intersect snap: sometimes it hasn't worked through the OSNAP settings, but will if selected individually (shift+right click = osnap shortcut menu).

 

2. are you SURE everything is at z=0?

 

I've used flatten in the past and have had problems with 3D polylines and also nested blocks? Some stuff like attributes have stayed "up in the air".

 

Try switching attribute display on, going to a side view and then zoom out and select all to see if anything is still above z=o.

 

Alternatively isolate the two lines that won't admit they intersect, if they're 3D polylines, select one at a time, open properties and cycle through the vertices to check they are all at z=0.

 

I don't think flatten works with 3D polys? If dbroada is still keeping an eye on this one perhaps he could confirm?

 

cheers

Link to comment
Share on other sites

... and just noticed that dave said the same thing as I did an hour earlier - DOH! :oops:
25 hours! (check the time stamp again Tiger) :)
Link to comment
Share on other sites

25 hours! (check the time stamp again Tiger) :)

 

oh hawt diggety...yesterday.. even worse - will promise to read threads more carefully next time :)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...