eweber Posted May 26, 2009 Share Posted May 26, 2009 I have two contour flanges (see image). The smaller radius flange will unfold to a flat pattern with no problem. On the other hand the larger radius contour flange will not unfold at all. When I hit flat pattern it just shows me an isolated view of the rail. Is there something I have to change or do I have to make the rail over again? Quote Link to comment Share on other sites More sharing options...
shift1313 Posted May 27, 2009 Share Posted May 27, 2009 were both parts created in the same manner? is the hidden part of the large arc the same is the close end of the smaller arc? Quote Link to comment Share on other sites More sharing options...
JD Mather Posted May 29, 2009 Share Posted May 29, 2009 Zip and attach the file here. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.