Jump to content

2010 Mech -vs- 2009 Mech


bigr1822

Recommended Posts

At the time we are using 2007 Autocad Mech and I am looking to upgrade. I have the disks for both 09 and 10. I would like to hear any comments any of you have to as why one is better than the other. Are there any issues with one verse the other?Does one have more instability issues then the other?Anything you can think of would great be apprecaited. Thanks in advance for you advice.Rodney

Link to comment
Share on other sites

  • 2 weeks later...

I don't have 2010 installed, but, one bit of advice is that 2010 has a new write format, so you cannot open the files created on that system with 2007 unless you save as a 2007 file. Only a small hassle, but one worth noting I think.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...