Jump to content

Corridor/surface contour creation???


JerryG

Recommended Posts

I have built a corridor surface by creating an alignment from

an existing corridor then targeting to another alignment/profile.

This all worked great but I cannot get the contours to show up

for the new corridor surface. I have created boundary's

through the corridor properties, but when I try and add a boundary

from the surface definition I get an error message.

Any thoughts?:? I'm running 2010

 

Thank you!

Link to comment
Share on other sites

I also found that when I go into the surface properties and Display everythin it changes the orginal corridor that I created the Alignment from rather than the new corridor/surface. I'm sure this is the problem but I'm not sure how to fix it?

Link to comment
Share on other sites

Turns out I simply had to click the Plus Icon in corridor properties under surface

(once a surface was created) and woala - contours show up.

This is because you have to specify that the surface you want the contours

to show up on is the TOP surface and not the Datum, Median, etc. surface

(if you have those for volume calcs)

Hope that helps

Link to comment
Share on other sites

  • 4 years later...
  • 2 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...