Jump to content

Embossing Text


DaleLloyd7569

Recommended Posts

I am trying to emboss text onto the surface of a tapered pipe but it keeps failing because the face is not tangent to the profile plane. Is there a way to do this?

450 x 375.zip

Link to comment
Share on other sites

You should state when you are not using the latest release as otherwise you might get a solution you cannot open.

 

Make the workplane tangent to the cone. Depending on design intent you might end up having to do each letter separately.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...