Jump to content

Drawing a lot plan using lot bearings


YuanMasipag

Recommended Posts

i need help...

how do i draw a lot plan using the orientations of the bearings given, say,

south 51-17 west, 212.06 meters...

any1 teach me...

i'm a beginner... thanx:)

Link to comment
Share on other sites

  • 7 years later...

Hi i got a plot plan to redraw in autocad, but something looks off with the bearings. I know bearing usually looks like this S30D57'08"E but the bearings on the plan looks like this N19d36'47" there is not direction at the end of it. :unsure:

Link to comment
Share on other sites

Unless the line is very close to vertical, you can usually tell which way it leans. One solution is to scan the plat and xref it temporarily. Once you have it scaled correctly, you can check your bearings and distances against it.

 

And whoever you got that plat from, tell them to go back to surveyor's school :P.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...