Jhun Gonzalo Posted July 24, 2009 Share Posted July 24, 2009 Hi All, a pleasant day to you all, i have some question regarding to an arc i have 635.46 arc length i need to modify it to 400.00 but i dont know how i try to check in properties but the arc length is locked and could'nt modify at all, any suddgestion how to modify it:oops: advance thanks to all, Quote Link to comment Share on other sites More sharing options...
Zorg Posted July 24, 2009 Share Posted July 24, 2009 I dont belive it possible to edit an arcs length by using the properties. I would either stretch it equal amount each end (to keep the height of the arc) or redraw it. Quote Link to comment Share on other sites More sharing options...
Zorg Posted July 24, 2009 Share Posted July 24, 2009 or always do a scale with reference of 635.46 then the new value of 400.00 but that will change the height of it unless you do various measurement then restore the hight to what it was previously. Quote Link to comment Share on other sites More sharing options...
lpseifert Posted July 24, 2009 Share Posted July 24, 2009 Use the Lengthen command (Total option) Quote Link to comment Share on other sites More sharing options...
mdbdesign Posted July 24, 2009 Share Posted July 24, 2009 "lengthen" should work?!?! I know is closer from Pittsburgh to England:D:D:D Quote Link to comment Share on other sites More sharing options...
Jhun Gonzalo Posted July 24, 2009 Author Share Posted July 24, 2009 Thanks mates, i just treid your suddgestions i think lengthen is my first option, the total length for 400.00 work fine only its not defined what will be the 2 ends of arc will be reduced. But this will help me a lot Many thanks, Quote Link to comment Share on other sites More sharing options...
mdbdesign Posted July 24, 2009 Share Posted July 24, 2009 Only changes will be made to end you selected: it will be extended You need to be sure which end need to be modify Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.