sakinen Posted September 4, 2009 Share Posted September 4, 2009 Is it posibile to connect pipe with small diameter to a pipe with a large diameter without a tee and reducer. Just small pipe welded into a biger pipe. Quote Link to comment Share on other sites More sharing options...
qbi Posted September 7, 2009 Share Posted September 7, 2009 Not it is not possible. Quote Link to comment Share on other sites More sharing options...
sakinen Posted September 8, 2009 Author Share Posted September 8, 2009 I just found out that it is possibile. You modify the duct takeot familiy and change the tap connection setting in your pipe familiy and it works. Quote Link to comment Share on other sites More sharing options...
lamsv Posted February 24, 2010 Share Posted February 24, 2010 How did you modify the duct take-out to work? I can't seem to figure that out... Quote Link to comment Share on other sites More sharing options...
sakinen Posted February 24, 2010 Author Share Posted February 24, 2010 Here's a ready family. Try it. Pipe Spud - Basic.zip Quote Link to comment Share on other sites More sharing options...
lamsv Posted March 8, 2010 Share Posted March 8, 2010 Thanks for the family. I gave it a try with mixed results. I was hoping for a family that would recognize the pipe diameters of the hosted family. But, with some editing, I bet I can get it to work. -Seth Quote Link to comment Share on other sites More sharing options...
rodvenables Posted May 18, 2016 Share Posted May 18, 2016 Thank you for sharing Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.