Nylg1 Posted September 28, 2009 Share Posted September 28, 2009 Hi there Was just hoping some may be able to point me in the right direction we use a very old version of AutoCAD 2002 LT which I have had no problem with. But I have some how run into a problem with when I do a drawing in model and all is fine then upon changing to layout all the hidden detail changes to solid lines and it prints the same. As far as I can tell all the settings are the same i.e Model and Layout. and now upon opening drawings I did years ago I have the same issue. Any ideas would be greatly appreciated Cheers Quote Link to comment Share on other sites More sharing options...
Marc-S Posted September 28, 2009 Share Posted September 28, 2009 Did you adjust the ltscale while in paper space? Quote Link to comment Share on other sites More sharing options...
nukecad Posted September 28, 2009 Share Posted September 28, 2009 Also look at PSLTSCALE and CELTSCALE. See this link http://www.cadtutor.net/forum/showthread.php?t=39256&highlight=psltscale Quote Link to comment Share on other sites More sharing options...
Nylg1 Posted September 28, 2009 Author Share Posted September 28, 2009 Thanks For your posts Guys very help full I was pulling my hair out thinking it must be simple.Changed PSLTSCALE to 0 and its fine now.. Thanks again Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.