Jump to content

Thread Hole Misfit Assembly Problem : Intereference in Assembly


DaMieN

Recommended Posts

Hi all..

I've got a problem about tapered holes and threads.

I created a (ISO) M6 tapered hole on a surface of part 1. Then I created another part (part 2) which is a simply a bolt that has threads of ISO M6.

Finally i try to make an assembly with them.

But my problem had started there.

After defining constraints, i did an "Interference Analyze"; and found out that there is an interference between threaded surfaces of part 1 and part 2.

Is it normal or i'm making a mistake while defining constraints..

 

 

Hope you help me: ]

Thanks..

Link to comment
Share on other sites

Sounds like something Inventor guru J.D.Mather might be able to assist you with. Let me give this thread a "bump". Perhaps he'll see it.

Link to comment
Share on other sites

When the Hole is modeled it uses the Minor Diameter of the hole for representation. When you modeled your bolt it was probably major diameter. This interference is normal to show engagement of threads. If you wish to change this method you can go to your part templates' document settings and change the setting on the model tab for Hole diameter creation.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...