Jump to content

Drawing this bearing housing


cute eng

Recommended Posts

  • Replies 123
  • Created
  • Last Reply

Top Posters In This Topic

  • cute eng

    36

  • JD Mather

    31

  • ReMark

    16

  • lulumara

    10

Top Posters In This Topic

Posted Images

As indicated earlier - some of it is undefined, but this should be correct at least to respect to the given dimensions. I decided after seeing the better image posted in other thread the the 125 does go to edge of part rather than to center of Ø16 hole.

How did you guys (gals?) do on the test? Can you share the test problems here (curious).

Bearing Holder.dwg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...