Jump to content

sketch not parallel


danmaus

Recommended Posts

New problem have not seen - I went to make a sketch on face of existing part but when i try to dimension sketch it shows lines at .01 degree angle (not square) to part even though sketch lines are horizontal and vertical constrained? Tried changing angle dimension to 0.00 but tells me over constrained? everything looks good but apparently not???:geek:

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...