danmaus Posted January 15, 2010 Share Posted January 15, 2010 New problem have not seen - I went to make a sketch on face of existing part but when i try to dimension sketch it shows lines at .01 degree angle (not square) to part even though sketch lines are horizontal and vertical constrained? Tried changing angle dimension to 0.00 but tells me over constrained? everything looks good but apparently not??? Quote Link to comment Share on other sites More sharing options...
JD Mather Posted January 15, 2010 Share Posted January 15, 2010 Zip and attach file that exhibits this behavior here. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.