JeStoneIV Posted January 25, 2010 Share Posted January 25, 2010 When putting in points using side shot it is asking for an angle in degrees (125.0000d). Can I change Civil 3d so that when inputting an angle like: 125.1209 it would be Degrees Minutes and Seconds instead of Degrees. Otherwise I have to input an angle like: 125D12'09" . Any suggestions? Quote Link to comment Share on other sites More sharing options...
lpseifert Posted January 25, 2010 Share Posted January 25, 2010 Toolspace > Settings > Rt-click on the dwg (at the top) Edit drawing settings > Ambient settings > Angle > Format > click on the value to get the options Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.