edbothma Posted February 19, 2010 Share Posted February 19, 2010 Is there a way to convert a orthographic drawing into a 3D object? Quote Link to comment Share on other sites More sharing options...
Glen Smith Posted February 19, 2010 Share Posted February 19, 2010 Automatically? No. However having the ortho makes it easier for the wetware to get to the 3D version. Plus it's good practice - how complex is the drawing and what is your schedule? Glen Quote Link to comment Share on other sites More sharing options...
edbothma Posted February 19, 2010 Author Share Posted February 19, 2010 Automatically? No. However having the ortho makes it easier for the wetware to get to the 3D version. Plus it's good practice - how complex is the drawing and what is your schedule? Glen Its a drawing of a COVER PLATE with bearings for three shafts. Now i've done the orthographic part and need to draw it in Isometric now..but i've got stuck on a certain point. I've attached the file and marked my problem with red circles on the isometric. As you would see its almost like a fillet or round area i need to draw. But to draw that in isometric, can it be done??? isometric 2.dwg Quote Link to comment Share on other sites More sharing options...
ReMark Posted February 19, 2010 Share Posted February 19, 2010 Then you're not doing a 3D drawing you're doing a normal isometric right? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.