Dou9las Posted March 3, 2010 Share Posted March 3, 2010 Have searched high and low and not found an explanation for this. I have a base file xref'd into my dwg, and am unable to use osnaps on any of the geometry when it is xref'd in. However when I open the xref in it's own session, osnaps work fine. I found by searching this and other forums that on the AEC tab (in options) there is an option to "optimize for speed" which, if checked, may hinder osnaps on xrefs - however, in my case, that option was/is not checked so should not be an issue. I have also toggled the whiparc system variable on and off, neither of which helped. Any help would be appreciated. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.