fohlmann Posted March 24, 2010 Share Posted March 24, 2010 I am a self taught novice in Autocad LT 2004, which I use to edit factory layouts. I simply want to add a dimension between two points and it is usually very straight forward. But on this particulary layout, the dimension disappears when I click to set it. The same goes when i try to draw a simple line or anything really. I can see it while i draw but when I click to finish it disappears. Any ideas? /Brian Quote Link to comment Share on other sites More sharing options...
ReMark Posted March 24, 2010 Share Posted March 24, 2010 You're drawing on a layer that is turned off. Quote Link to comment Share on other sites More sharing options...
fohlmann Posted March 24, 2010 Author Share Posted March 24, 2010 And a million lines and dimensions appeared... I should have registered here much sooner - cheers! Quote Link to comment Share on other sites More sharing options...
ReMark Posted March 24, 2010 Share Posted March 24, 2010 I was blind now I can see. Ain't life grand? Welcome to the CADTutor forum fohlmann. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.