Jump to content

Inserting Block problem


happyunited

Recommended Posts

Hi, I am trying to copy a block with some attributes into another drawing. I am trying to copy from dwg 1 to dwg 2. The UNITS & INSUNITS in both dwg 1 & 2 are both set to 0 but when I insert the block it itself come in in the right place but the attributes are scaled up by 1000???

 

Any ideas?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...