donzie67 Posted April 12, 2010 Share Posted April 12, 2010 I am having a problem when selecting a hatched object in 2011. It takes forever to do so. Did not have this problem in 2010. Does anyone else have this problem and is there a cure? Quote Link to comment Share on other sites More sharing options...
Dana W Posted April 12, 2010 Share Posted April 12, 2010 I am having a problem when selecting a hatched object in 2011. It takes forever to do so. Did not have this problem in 2010. Does anyone else have this problem and is there a cure? Is your hatch very dense and/or very large? Is it on a layer with a really wide line width setting? The closer to minimum size your graphics card is, the more this sort of stuff can be a problem. I had that issue a bit with my 2009. I don't even try to use ARSAND any more for that same reason except in areas less than 20 or so units square. I tried to hatch an area of about 12 acres with it and I thought I could smell my computer burning while Acad was off counting the sand. Quote Link to comment Share on other sites More sharing options...
donzie67 Posted April 12, 2010 Author Share Posted April 12, 2010 This was a predefined solid hatch that I used in my title block back in 2002 that for some reason was not happy in 2007. I have to go into the block with block edit and select the patern type that is now "User-defined" and select "predefined" and then in patter chose "Solid". We now have changed the title of our division and I have to go into each title block and rename and redefine the hatch patern for out logo. I was getting use to it in 2010 as just another thing needing to be done. With 2011 it is the same thing needing to be done but now it takes 6 seconds longer for each block. With 1000's of blocks needing the same thing done it just became a longer project. I hope there is a solution to come soon. Quote Link to comment Share on other sites More sharing options...
Dana W Posted April 12, 2010 Share Posted April 12, 2010 This was a predefined solid hatch that I used in my title block back in 2002 that for some reason was not happy in 2007. I have to go into the block with block edit and select the patern type that is now "User-defined" and select "predefined" and then in patter chose "Solid". We now have changed the title of our division and I have to go into each title block and rename and redefine the hatch patern for out logo. I was getting use to it in 2010 as just another thing needing to be done. With 2011 it is the same thing needing to be done but now it takes 6 seconds longer for each block. With 1000's of blocks needing the same thing done it just became a longer project. I hope there is a solution to come soon. Your Graphics card is OK, but you could check to see if your graphics driver is on this list for 2011. http://usa.autodesk.com/adsk/servlet/hc?siteID=123112&id=6711853&linkID=9240618&is_results=1&card_sel=0&manufac=4318&card=1038-4318&cert=0&d_stat=1&d_stat=2&prod=AutoCAD-R17.2&prod=AutoCAD-R18.0&prod=AutoCAD-R18.1&os=1&os=512&os=256&os=2048&os=4096&os=8192 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.