Jump to content

Dynamic Blocks - Circles (Rebar)


Sparky

Recommended Posts

Morning,

 

I'm trying to create a dynamic block for various rebar sizes. I started with a circle and applied a linear parameter with a stretch action so as to stretch the rebar equally in all four dirctions so I could maintain the center point. The circle didn't work so I tried using (2) polyline arcs and I still had no luck. I have attached the file that I started with. I would like to have this set up so I could have a #3 (3/8" DIA.) rebar, #4 (1/2" DIA.).... Which parameter do I need? Thanks!

Rebar -4-19-10.dwg

Link to comment
Share on other sites

dbroad,

 

You da man. I applied a linear parameter from the center to the right quadrant and a linear parameter center to the left quadrant, applied a scale action to each parameter and specified the raduis in the look up parameter and it works great. Thanks for your help. Have a blessed day!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...