Jump to content

insert Jpeg file


SadisticIron

Recommended Posts

I have a drawing of a logo that is in a jpeg format and I want to either some how trace the logo or insert it into autocad so i can cut this logo out on the plasma table. Any help would be greatly appreciated since I am a newbie to all this.

 

Thanks:D

Link to comment
Share on other sites

I can do that but once the image is in there I can not adjust, copy or trace it to arcs and lines for cutting on the cnc table. will I have to do this with the layer application.

Link to comment
Share on other sites

I can do that but once the image is in there I can not adjust, copy or trace it to arcs and lines for cutting on the cnc table. will I have to do this with the layer application.

 

What software does your Plasma Cutter use? It may or may not have "Raster to Vector" built in which would do the conversion for you.

 

Our Omax waterjet layout software has Intelli-trace but it's a hit and miss proposition depending on how complicated the raster file is. I don't even use it anymore.

 

I did have some success with this application on a clean pdf. I seem to have had better results using pdf rather than jpg.

 

Give it a try.

http://www.aidecad.com/

 

KC

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...