pinco pallino Posted April 28, 2010 Share Posted April 28, 2010 Sheet metal. How to? I'm not familiar with the all business of sheet metal. When a face is big needs to be “faceted”. ( I don't know the right term) So to say, it mast be pressed out as a shallow pyramid, this is to avoid drumming effects. See pic. How is that done in inventor? Cheers. Quote Link to comment Share on other sites More sharing options...
JD Mather Posted April 28, 2010 Share Posted April 28, 2010 Later versions of Inventor have Cross Break (cosmetic). Quote Link to comment Share on other sites More sharing options...
pinco pallino Posted April 28, 2010 Author Share Posted April 28, 2010 Thanks JDM. I'm about to upgrade to IV 2011. can't wait. Kind Regards. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.