Jump to content

How to move the endpoint of a line


cercapatch

Recommended Posts

Hi.

I used to do this but I have forgotten how I did it:

I have a line with two endpoints and I want to move one endpoint to another location. Of course I can move the cursor to the endpoint I want to move, click on the grip and drag it to another location. But I know I could sellect the line, do something which I do not remember and simply click somewhere else on the drawing then the endpoint of the line closer to where I click would jump to where I clicked.

Does somebody know how to do this?

 

Thanks

 

Please e-mail me if you will.

feri_b@yahoo.com

Link to comment
Share on other sites

I believe it is the "change" command. Can be applied to multiple lines at once. I'll bet this command is rarely used by anyone....me included.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...