Jump to content

Reactor + bcount Is it possible?


titoprax

Recommended Posts

Good night from Spain. Forgive my bad English.

 

I would like to know if it is possible through Reactor automatically blocks or Lisp count?

 

The idea would be:

A legend with symbols (blocks) put each symbol on the plane and in the same legend that was the total number of symbols appearing there in the plane.

Link to comment
Share on other sites

Command ._DataExtraction is not really what I want.

I´m just looking for the possibility to insert a legend of symbols (block) and when I use ine of these symbols in a drawing, the legend is updated automatically

 

Example:

Legend of symbols BEDS. If I insert a symbol (i.e 90cm bed) the legend will update the number of that symbol every time I use it.

It is like a symbol counter in the legend.

Leyend. Produccion Mecanica (Rociadores).zip

Link to comment
Share on other sites

I´m just looking for the possibility to insert a legend of symbols (block) and when I use ine of these symbols in a drawing, the legend is updated automatically

Have you actually tried using it? What you describe is possible with ._DataExtraction. You can export the results to a table in the drawing, which updates when additional blocks are added or removed.

Link to comment
Share on other sites

updates when additional blocks are added or removed?

I can not do with the application _DataExtraction. As will this take?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...