Frazer1987 Posted May 13, 2010 Share Posted May 13, 2010 Right i have opened a new layout, how on earth do you get a viewport created for this layout, probably simple but it aint happening so far? thanks Quote Link to comment Share on other sites More sharing options...
MSasu Posted May 13, 2010 Share Posted May 13, 2010 Try MView command; press F1 for more information. Regards, Quote Link to comment Share on other sites More sharing options...
Frazer1987 Posted May 13, 2010 Author Share Posted May 13, 2010 how do you change your layout/viewport to print horizontally instead of vertically? Quote Link to comment Share on other sites More sharing options...
ReMark Posted May 13, 2010 Share Posted May 13, 2010 Orientation of plots can be controlled in the Plot dialog box. Quote Link to comment Share on other sites More sharing options...
MikeScott Posted May 13, 2010 Share Posted May 13, 2010 Plot dialogue is the same dialogue as page set-up (right-click on active tab name) Or.. within plot dialogue, hit the "save to layout" button. Quote Link to comment Share on other sites More sharing options...
joewaianae Posted May 13, 2010 Share Posted May 13, 2010 some times we have had to turn the whole thing. type ucs, on prompt type "z", then say 90. your not done, then type "plan" then say current. this is all done while in layout and in model space while on the layout....(make sence?) NOT IN MODLE. that will turn everything only in the viewport. When you go to the Model it is still orentated the correct way. Quote Link to comment Share on other sites More sharing options...
ReMark Posted May 13, 2010 Share Posted May 13, 2010 how do you change your layout/viewport to print horizontally instead of vertically? The OP asked about printing not about rotating the viewport or the images contained within. Unless he mis-spoke. Quote Link to comment Share on other sites More sharing options...
joewaianae Posted May 13, 2010 Share Posted May 13, 2010 Nooooo Remark, you are correct I think I am the one who mis-spoke..... my bad Quote Link to comment Share on other sites More sharing options...
MikeScott Posted May 13, 2010 Share Posted May 13, 2010 I was thinking "change your layout to print horizontally" was more of a descriptor of a layout change. Otherwise if I was the one asking, I'd have said "How do I print my layout sideways" or something. Dunno'.. guess it could be read different ways.. no harm done. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.