herb6874 Posted May 17, 2010 Share Posted May 17, 2010 I have been receiving often this message when I go to File/open "Application does not support Windows Forms just-in-time (JIT) debugging. Contact the application author for more information." It does not happend all the time Any switch I should turn on/off Please help HR Quote Link to comment Share on other sites More sharing options...
ReMark Posted May 17, 2010 Share Posted May 17, 2010 As I recall the full error message is fairly long. But right up near the top there should be a line that starts off reading... Could not load file or assembly... It is what comes after those words you need to look at since the name of the file that is causing the problem should be listed. Quote Link to comment Share on other sites More sharing options...
lonelysn Posted August 12, 2015 Share Posted August 12, 2015 Hai Friends, I had also faced the same problem. ____________________________________________________ Application does not support Windows Forms just-in-time (JIT) debugging. Contact the application author for more information. ____________________________________________________ this appears when i use NETLOAD (ENTER)-(BROWSE)DGNPURGE(ENTER) THEN --- DGNPURGE (ENTER) Please help:(:!: Quote Link to comment Share on other sites More sharing options...
SLW210 Posted August 12, 2015 Share Posted August 12, 2015 If you are purging DGN Lintypes, AFAIK 2015 has the DGNPurge included in the standard PURGE command. Hard to tell what exactly is giving you the message without more information. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.