Jump to content

Publish DWF problem


richard3009

Recommended Posts

I have a set of 20 drawings I wish to publish as a DWF the drawing is in model space but the border is an attributed block placed in the layout tab.

 

For some reason the dwf publisher is chopping the very right hand side of the border, I have done a zoom extents on both layout and model space before saving the drawing and the viewport is locked in the correct position, any ideas as to why it would chop the border.

Link to comment
Share on other sites

You probably need to look at the paper size the DWF printer is useing. Either customise the printer to make the non printable area smaller, or shrink your border a little.

Link to comment
Share on other sites

what does the dotted line represent in the layout tab

 

That is your printable area. Keep the viewport inside it. Unlock it and slide the grips until it is inside the dotted line. ZOOM WAAAAAY IN. on the grips before moving them so you will be JUST inside the dashes.

Link to comment
Share on other sites

sorted problem thank you they just needed centering to paper and fitting to page

 

That's ok when you don't need the scale to work out.

 

Glad you found a way.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...