Jump to content

Visibility States


chelsea1307

Recommended Posts

I would like to make this a dynamic block, where at any one instance on one of the T's coming off the center is showing, with names like right, left, top, bottom. I can create visibility parameter but cannot connect a name to what is shown/not shown

ts.jpg

ts.dwg

Link to comment
Share on other sites

figured it out, check out commands BVSHOW and BVHIDE if your having difficulties figuring these out

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...