Jump to content

nut


petdem

Recommended Posts

How do i place a edge on the top/bottom nut section on this stem.I tried by using Extrude command and selecting Intersect + 45 degree angle Taper.When i used this combination it places the Taper on the nut but removes the rest of the part.Can this be done or do i need to create the Nut and Taper first and then do sketches/Extrude for the rest.

 

Cheers....Pete

nut.zip

Link to comment
Share on other sites

Always do the Hex extrusion first.

Then the Extrude(s) taper intersection(s)

Then finish the part cylindrical shaft(s).

 

Your other option is to do a Revolve - Cut on the hex.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...