petdem Posted June 4, 2010 Share Posted June 4, 2010 How do i place a edge on the top/bottom nut section on this stem.I tried by using Extrude command and selecting Intersect + 45 degree angle Taper.When i used this combination it places the Taper on the nut but removes the rest of the part.Can this be done or do i need to create the Nut and Taper first and then do sketches/Extrude for the rest. Cheers....Pete nut.zip Quote Link to comment Share on other sites More sharing options...
JD Mather Posted June 4, 2010 Share Posted June 4, 2010 Always do the Hex extrusion first. Then the Extrude(s) taper intersection(s) Then finish the part cylindrical shaft(s). Your other option is to do a Revolve - Cut on the hex. Quote Link to comment Share on other sites More sharing options...
petdem Posted June 4, 2010 Author Share Posted June 4, 2010 Thanks for the advice Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.