WCCSAM Posted June 4, 2010 Share Posted June 4, 2010 Auto cad is just shutting down by itself and i am getting this message FATAL ERROR: UNHANDLED ACCESS VIOLATION READING 0x1e27360 Exception at 1e27360h Does anybody have any ideas on solving this. Quote Link to comment Share on other sites More sharing options...
MSasu Posted June 4, 2010 Share Posted June 4, 2010 Try to open the drawing using RECOVER command - it may help. Regards, Quote Link to comment Share on other sites More sharing options...
CJJ Posted June 4, 2010 Share Posted June 4, 2010 When do you get the error? Is it when you load the program, open a specific drawing, perform a specific command, or just randomly at different times? Quote Link to comment Share on other sites More sharing options...
WCCSAM Posted June 4, 2010 Author Share Posted June 4, 2010 It seemed to be randomly while in one certain dwg. But I just ran a "RECOVER" on the dwg and It fixed like 176 problems. So I am hoping that the problem may be solved. Quote Link to comment Share on other sites More sharing options...
CJJ Posted June 4, 2010 Share Posted June 4, 2010 Good deal. Might want to run AUDIT as well as recover. I always do both just to make sure i'm fixing everything. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.