gsksun4 Posted June 7, 2010 Share Posted June 7, 2010 I'm in a particular drawing from a customer and the polygon and rectangle command doesn't work. When I do rectangle, only one line from the snap point shows, not the other three. With polygon, you pick a point and usually can see the object when you drag to the next. Here it doesn't show. Circle same thing. All it does is drag a single verticle line with ortho on or off. Revision cloud a series of small verticle lines. Filedia, pickfirst and pickadd all set to 1. Is there another setting? Layer is on, thawed and not frozen. Also, I just tried to draw a square with the line command with the ortho mode on. It's stuck in a 1 verticle line only mode. Blocks with attributes don't work either. Any help would be appreciated. Glenn 2009LT Quote Link to comment Share on other sites More sharing options...
RobDraw Posted June 7, 2010 Share Posted June 7, 2010 Sounds like a UCS issue. Quote Link to comment Share on other sites More sharing options...
rkent Posted June 7, 2010 Share Posted June 7, 2010 try UCS, World PLAN, World Quote Link to comment Share on other sites More sharing options...
gsksun4 Posted June 7, 2010 Author Share Posted June 7, 2010 try UCS, WorldPLAN, World Man you guys are good. I thought I was gonna be left on my own with this one. Everything works fine now. Thank you both so much. Glenn Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.