Jump to content

Drawing a Car Wheel in AutoCAD (HELP)


Bobzy20

Recommended Posts

Does anybody know how I would get the Extruded Red circles (holes) in the 1st image below to look like the holes in the 2nd image below?

 

I’m drawing the wheel in AutoCAD from a tutorial which has been drawn in SolidWorks.

 

The small Extruded hole in the middle will go right through the wheel but the larger Extruded hole only needs to be Extruded until it hits the wheel surface (as per 2nd image).

 

Help would be great.

 

Thanks

 

Bobzy20

Link to comment
Share on other sites

Draw half of the hole longitudinal section and revolve it around axis, place it in appropriate pozition on wheel and after subtract it from wheel. Done.

attachment.php?attachmentid=21155&stc=1&d=1277299519

Regards,

Link to comment
Share on other sites

Hi thanks for the replies although I still can't do it. :(

 

Bobzy20

 

Draw your profiles, (in green), then press pull the larger hole for the counterbore then the smaller straight through for the hole...

 

 

wheel.png

 

KC

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...