Jump to content

View port layers do not show up? In model all layers show up?


muck

Recommended Posts

My view port layers do not show up. I model space all layers show up.

Is there a way to make all my view port layers show up. I have been

looking in the right hand side of my screen and everything is turn on

on the layer that does not show up.

 

thank you,

Link to comment
Share on other sites

From the sounds of your problem you might have done some drawing in the Paper Space. If the layers you created are drawn in the paper space they would never show up in model space, at least to my knowledge.

Link to comment
Share on other sites

My view port layers do not show up. I model space all layers show up.

 

If the geometry was created in the layout, then it will not show up in MS.

It is also possible that the layers are frozen only in the viewport.

Use the ._Vplayer command to thaw viewport-only frozen layers.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...