Jump to content

Strange problem in FILLET command in AutoCAD 2011

archash

By archash
in AutoCAD Bugs, Error Messages & Quirks

 Share

Recommended Posts

archash Newbie

archash

Posted
Posted

Sometimes In AutoCAD 2011, when i fillet two lines very close to each others with radius 0, the first line move closer to the second line instead of extending them in the same direction!

 

 

 

Can anyone help?

Link to comment
Share on other sites
  • 2 weeks later...
AVITWeb Contributor

AVITWeb

Posted
Posted

I too have see this i the past. Sometimes the angle of the line will change ever so slightly as well. I have not seen whether it is a video card thing or an ACAD problem. I have seen this in the last few versions.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...