Jump to content

Command Line Prompt For Add Attribute


Cat

Recommended Posts

Does anyone know if there is a command line prompt for the Add Attribute function? I'm writing a script and haven't been able to find any reference to it in my reference material. Thanks

Link to comment
Share on other sites

No, -ATT is the same as -ATTDEF which defines an attribute. The command I'm attempting to invoke actually adds an attribute to a predefined block, but thanks for trying.:)

Link to comment
Share on other sites

I've come to the conclusion that the task I was trying to accomplish can't be done with a script because the "utility" within the command "Add Attribute" is not currently supported. If the I/O modules had been assembled in a "block" format as opposed to "parametrically" built, it would have been as simple as updating the affected blocks and replacing them throughout the Project. It's a rare circumstance that you would ever have to do that at the end of a job, but on the rare occasion that you might, it sure is less expensive to be able to, as opposed to manually manipulating each I/O module.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...