Jump to content

re-sizing pipe end connector call-out


frankcad

Recommended Posts

So not sure if this is titled correctly, when i draw a pipe it automatically throws down 2 ! inside a triangle to let me know its not connected. my question is how can i resize them? there gigantically big, my annotation scale and everything is 1:1 im in the model space i cant figure out how to resize them or just shut them off. any help? New to MEP and 3D itself have a lot to learn

Link to comment
Share on other sites

Well i use no-hub. i set my routing preferences have that all good with the correct fittings and everything, its just these pipes that when i draw and don't have connected the call-out for it is so big, i want to make it smaller

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...