nicolas Posted August 10, 2010 Share Posted August 10, 2010 HI, I have been using Windows Copy/Move by using ctrl+dragging any object (except the grids) or simply dragging the object. However, one limits I noticed so far is that I can't go beyond the actual screen. I have to move the objects twice/thrice in order when the destination is far away. This is not the case with the MOVE/COPY SELECTION command where I can pan. Is there any solution to the problem that I am missing? Thank you in advanced, Nicolas. Quote Link to comment Share on other sites More sharing options...
hoss Posted August 12, 2010 Share Posted August 12, 2010 You should be able to use your mouse wheel to zoom in or out while dragging objects Quote Link to comment Share on other sites More sharing options...
nicolas Posted October 29, 2010 Author Share Posted October 29, 2010 Sorry for the late reply but with windows move/copy type, I can't zoom in/out with the mouse wheel at the same time. The objects only move/copy within the scope of the available display limit. Quote Link to comment Share on other sites More sharing options...
JBullseye74 Posted October 29, 2010 Share Posted October 29, 2010 Correct you can't zoom when doing it this way. To be honest i would change the way you are doing it and use the COPY command this gives you more flexability and allows you to pan / zoom around your drawing whilst the command is active. Quote Link to comment Share on other sites More sharing options...
ReMark Posted October 29, 2010 Share Posted October 29, 2010 You could try using the Aerial View feature (command line: dsviewer). Refer to your Help file for more information. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.