Jump to content

what is chamfer and fillet while drawing rectangle ??


XuFyan

Recommended Posts

i've tried chamfer, it asks for 1st chamfer distance then second chamfer distance

and then it asks for the First corner and other corner but i didn't see any difference in the rectangle after it is drawn

Link to comment
Share on other sites

seen this figure,

 

untitled.JPG

 

and the commands are,

 

 

Chamfer/Elevation/Fillet/Thickness/Width/: c

 

First chamfer distance for rectangles : 100

 

Second chamfer distance for rectangles : 200

 

Chamfer/Elevation/Fillet/Thickness/Width/: 0,0

 

Other corner: 5,5

Link to comment
Share on other sites

your chamfer distance are too large- the rectangle is only 5x5

try 1 & 2 and see what happens

 

Maybe you ought to look in Help for Chamfer to get a better idea of what you're doing.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...