bfloresf1 Posted August 31, 2010 Share Posted August 31, 2010 (edited) if I have a layout where I have places some screw tap and screws, but during the layout phase the engineer has move these from being on a .005 snap to some other funky decimal, is there a lisp routine i could use to move the object back to a .005 snap? Can anyone help me? or point me in the right direction. Edited August 31, 2010 by bfloresf1 Quote Link to comment Share on other sites More sharing options...
BIGAL Posted September 1, 2010 Share Posted September 1, 2010 Why are you working at 0.005 ? doesn't make sense its also prone to problems sometimes autocad doesn't like snaps below 1 have had this problem. Anyway SNAP 0.005 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.