Jump to content

Perspective View - Can't get consistant view of small objects


numberOCD

Recommended Posts

Hey AutoCADians,

I'm working on a projection of (4) sets of (4)L4x4x3/8 to show the offset from the expected location. The offset is down to as small as 0.0045'. When I show a close up perspective view of the end of the L-Brackets, my first (3) sets come out good and close in a 3.45"x3.71" viewport; but the forth keeps cutting into the L-Brackets. Anyone have any tips to set the boundaries of that perspective view cutoff or anything about possible technique??

Edited by numberOCD
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...