Jump to content

Assemblies for parts


ko31505

Recommended Posts

If I want to attach a few fuses with a disconnect that I just placed in the system how would I go about doing it on a permanent basis but at the same time be able to use the fuses I place inside the disconnect by themselves every once in a while? When in the Edit/Insert Component Box I select Mutiple catalogs, find the fuse and add three of them to the part. The next time I add one of the disconnects, the fuses I assigned to it are no longer with it. What should I be doing?

 

 

 

Thanks

 

Bill

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...