Jump to content

Help) How can I bend a 3d


Mr guiff

Recommended Posts

Something like this? I did not use your dimensions.

 

3D_Bent Bar.jpg

 

Done using the SWEEP command. The "path" (single line) was drawn with the UCS reoriented.

 

Users of older versions of AutoCAD (ex. - 2000) do not have the SWEEP command. Use the EXTRUDE command instead. Placement of the object to be swept is critical. Your results may vary.

Edited by ReMark
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...