Jump to content

DVB project is loaded incompletely on Bricscad Pro v10


MSasu

Recommended Posts

I got a DVB project developed by someone else and need to get it installed on some workstations that run Bricscad Pro v10; it load and works correctly on all except one. In fact on this troublemaker station it is loaded without error but when try to run his macros get the message "Run-time error 424 Object required".

When checked the loaded components I found that no form was in fact loaded (were about 15 forms) and only few modules are available - compared with station were it works. So, seems that something prevent the DVB file to be loaded completely.

 

Did someone encounter a similar issue?

Is there a way to debug loaded features since no error is issued when DVB file is loaded?

 

Any help will be appreciated. Thank you.

 

Regards,

Mircea

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...