Jump to content

Getting mleader text to come in vertical


Michael83

Recommended Posts

Hi all, I just purchased Autocad 2010 and going through the mleader settings I can't figure out which settings will have the mtext come in at a 90 deg. angle. The option to have the text placed for "reading from right" places the text at maybe a 80 deg. angle w/ ortho on. The horizontal setting does its job. Could I be overlooking a setting? Greatly appreciate your suggestions.

Link to comment
Share on other sites

One solution would be to rotate your UCS by 90 degrees. That way, as far as the MLeader command knows, the text is horizontal. You can save the UCS, restore the previous one, and reload the labelling UCS whenever you need it.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...